BRITISH COLUMBIA CLASS 1 LICENCE TEST 1

0 votes, 0 avg
7

BRITISH COLUMBIA CLASS 1 LICENCE TEST 1

1 / 30

Which of the following is correct about assisting a person in a wheelchair?

2 / 30

When are drivers of emergency vehicles are exempt from the Distracted Driving Law?

3 / 30

What lights would not be found at the rear of the vehicle of a bus?

4 / 30

Which of the following is the correct procedure for stopping at an uncontrolled railway crossing with a Class 2 vehicle?

5 / 30

What is considered a safe distance from the bus to bring your passengers if you notice a fire while on route?

6 / 30

When entering a right curve in a large vehicle, the driver should:

7 / 30

What is the maximum time a driver has to deliver a daily log to the employer under this Province's Hours of service legislation?

8 / 30

What are the warning signs of driver fatigue?

9 / 30

Which of the following is not required as part of a carrier's Safety Plan?

10 / 30

In what situations would the use of CB radios be exempt from the Distracted Driving Law?

11 / 30

Which of the following is a driver with a Class 1 licence not able to operate?

12 / 30

Which of the following situations could be unsafe when unloading a Class 3 vehicle into a hopper?

13 / 30

When loading a dump vehicle, what is one of the steps you must follow before moving the vehicle?

14 / 30

Carriers operating a tractor outside of this Province are required to obtain a Safety Fitness Certificate if the vehicle weighs in excess of:

15 / 30

Qualifying for an air brake endorsement is mandatory to obtain what type of licence?

16 / 30

To safely complete a left turn in a large vehicle, it is recommended that you:

17 / 30

Which of the following statements about the federal Hours of service regulations is true?

18 / 30

What is the minimum seating capacity (including the driver) for a commercial vehicle to be considered a 'bus' under the Traffic Safety Act?

19 / 30

When should you use a guide to assist with reversing?

20 / 30

What is the most critical task in the coupling procedure?

 

21 / 30

When is an air brake 'Q' endorsement required?

22 / 30

What is lag time?

23 / 30

Which of the following statements about braking force is true?

 

24 / 30

Which is not one of the four conditions for having the daily log requirement waived under Alberta's Hours of service legislation?

25 / 30

Which of the vehicles below would be required to stop at all uncontrolled railway crossings?

 

  • a. A 16-passenger tour bus
  • b. A truck that has just finished unloading a delivery of flammable liquids
  • c. A semi-trailer carrying corrosive materials
  • d. An ambulance

 

 

Why are railway crossings potentially more dangerous for larger, heavier commercial vehicles?

 

  • a. These vehicles need more time to clear a crossing
  • b. These vehicles need to stop farther away from a crossing before proceeding safely
  • c. These vehicles need more speed to clear the crossing
  • d. These vehicles have to overcome the centrifugal force acting upon them

 

 

Corrosive materials can corrode:

 

  • a. Internal tissue
  • b. All answers are correct
  • c. Human skin
  • d. Metal

 

 

If a 'reserved lane' sign includes a list of hours of the day or days of the week on it, what do these mean?

 

  • a. They indicate when the vehicles represented on the sign are not permitted to drive in that 
  • b. They indicate when any vehicle can drive in that lane
  • c. They indicate when that lane is reserved
  • d. They indicate when that lane is not reserved

 

 

When reversing a semi-trailer, you should:

 

  • a. Honk the horn only if there are other vehicles or bystanders in the vicinity
  • b. Turn the steering wheel in the opposite direction to where you want the trailer to go
  • c. Tap the throttle gently to begin reversing
  • d. Turn the steering wheel in the same direction to where you want to go

 

 

If safety marks are needed to indicate the presence of dangerous goods, where on the vehicle should they be placed?

26 / 30

When performing the pre-trip inspection for a truck-tractor or three-axle vehicle, it is essential to verify the following:

27 / 30

When parking a school bus downhill (on the right-hand side of the road), which of the following should you not do?

28 / 30

When inspecting the power steering pump and hose during a pre-trip inspection, you should check for the following:

29 / 30

Clearance lights are required for vehicles that are wider than:

30 / 30

What does having the 'S' condition code on Class 1, 2, or 4 licences signify?

BRITISH COLUMBIA CLASS 1 LICENCE TEST 2023

What is a Class 1 Licence in British Columbia?

A Class 1 Licence in British Columbia allows you to operate a motor vehicle with a gross vehicle weight rating (GVWR) over 11,794 kg or any combination of vehicles where the towed vehicle has a GVWR of more than 4,600 kg.

Who is eligible to apply for a Class 1 Licence in British Columbia?

To be eligible for a Class 1 Licence, you must be at least 19 years old and have a Class 5 (full-privilege) driver’s licence in British Columbia.

What are the steps to obtain a Class 1 Licence in British Columbia?

The steps generally include passing a knowledge test, obtaining a learner’s Class 1 licence, completing a training program (if applicable), and passing a road test. The road test typically consists of a pre-trip inspection, an air brake test (if applicable), and a practical driving examination.

What topics are covered in the Class 1 Licence knowledge test?

The knowledge test includes questions related to air brakes (if applicable), safe driving practices, traffic laws and regulations, and general knowledge about operating Class 1 vehicles.

How can I prepare for the Class 1 Licence knowledge test in British Columbia?

You can prepare for the knowledge test by studying the British Columbia Commercial Driving Manual, which is available online. You can also take practice tests to assess your knowledge and identify areas where you might need additional study.

Do I need to take an air brake endorsement test for a Class 1 Licence?

If you plan to operate vehicles equipped with air brakes, you will need to obtain an air brake endorsement. This may require passing an air brake knowledge test in addition to the Class 1 Licence knowledge test.

What are the fees associated with getting a Class 1 Licence in British Columbia?

The fees for a Class 1 Licence can vary, and they may include the knowledge test fee, learner’s licence fee, and road test fee. There may also be additional costs for any required training programs.

Are there age restrictions for obtaining a Class 1 Licence in British Columbia?

Yes, you must be at least 19 years old to apply for a Class 1 Licence in British Columbia.

Is there a waiting period between passing the knowledge test and taking the road test for a Class 1 Licence?

The waiting period can vary, but generally, you will need to hold a Class 1 Learner’s Licence for a certain period and gain practical experience before taking the road test. This waiting period may be several months.

How long is a Class 1 Licence valid in British Columbia?

In British Columbia, a Class 1 Licence is typically valid for five years. You will need to renew it before the expiry date to continue driving commercially.

What is the difference between a Class 1 Licence and other commercial driver’s licences, like Class 2 or Class 3?

Class 1 allows you to drive the heaviest and most complex vehicles, typically tractor-trailers or semi-trucks. Class 2 and 3 licences are for buses and trucks of lighter classifications, respectively.

Please note that regulations and requirements may change over time, so it’s important to check with the British Columbia Ministry of Transportation and Infrastructure or visit their official website for the most up-to-date information regarding Class 1 Licence requirements and testing procedures.

BC driver handbook

Leave a Comment

Your email address will not be published. Required fields are marked *